Working Groups: 5.31 5.32 5.33 5.34
Completed research 5.31
Completed research 5.32
- A modular measurement standard and procedure for task-specific and temporal increase of the accuracy of coordinate measuring machines (ModulaNo)
- Online correction of coordinate measuring machines using compensation of the refractive index of air - MNPQ
- Traceable in-process dimensional measurement (TIM)
- TraCIM
- Qualifizierung der 3D-Koordinatenmesstechnik zur standardisierten Bildung von Bezügen und Bezugssystemen
- Messtechnische Rückführung von Messungen mit Lasertrackern
- Virtual Measurement Process VMP – Transfer of the VCMM concept to additional Metrological Digital Twins within the CC VirtMet
- GEMiMEG-II: Secure and Robust Calibrated Measuring Systems for the Digital Transformation
Completed research 5.33
- Installing a Competence Center “WIND” to enhance metrology for the increase in efficiency of Wind Energy Systems (WIND)
- Increasing the availability and the quality optimization of drive train components and gears for wind power plants - EVeQT
- Metrological traceability of shaft measuring instruments - SHAFT
- Traceable and robust calibration procedures for internal microstructures
- Concept, manufacture, testing and specification of a stiffness-adapted microprobe made of plastics for use in three-dimensional coordinate measuring machines
- Development of procedures for capability tests of measuring instruments for micro gear measurement
- National comparison with large gear measurement standard
- 3D tactile microprobe with isotropic mechanical properties for the transfer into industrial micro coordinate measurement technology
Completed research 5.34
- Metrology for Additively Manufactured Medical Implants (MetAMMI)
- Task-specific monitoring of industrial computed tomography measurements - CT-ÜW
- Development of a novel method for quality evaluation of micro milling tools based on virtually determined single-point uncertainties - Q MikroWz
- International Network for the Training of Early stage Researchers on Advanced Quality control by Computed Tomography (INTERAQCT)
- Metrology to Enable High Temperature Erosion Testing (METROSION)
- Multi-sensor metrology for microparts in innovative industrial products (Microparts)
- Testing of area measuring 3D micro measurement procedures for dimensional measurement tasks
- Software-based determination and application of quality measures in dimensional computed tomography - CT-QM
- Traceable tactile-optical 3D measurement of micro geometries with very a small probing element
- Workpiece influence on high-precision coordinate measurements with optical distance sensors